BMW 2800, 3.0, Bavaria (1968-1976) - Brakes - Brake Hoses and Lines

BMW 2800, 3.0, Bavaria (1968-1976) Brake Hoses and Lines - UUC Brake Lines

Brake Hoses and Lines

If a car wont run that's not good, if a car wont stop that's BAD! Brake hoses and lines connect the master cylinder to the calipers. Over time, brake lines can eventually wear out, develop cracks, cause leaks, and even explode due to fatigue. They should be checked whenever servicing your brakes.

UUC Stainless Steel Brake Lines

Original brake lines are rubber and can expand under the normal pressure of use. This expansion of the brake line negatively affects the brake caliper piston travel, and makes for mushy pedal feedback.

UUC's Stainless Steel Brake lines are used to "performance tune" your braking system.

Inner Teflon line is covered with woven stainless steel braid that will not expand under pressure. The advantages include better brake pedal feedback and a firmer pedal, along with superior brake modulation. Results will be immediate.

fully compliant with DOT Standards (MVSS-1006)
lines burst-tested to 6000psi (maximum tested pressure from a BMW braking system is 1200psi)
Teflon inner line covered with a woven layer of stainless steel and covered in an abrasion-resistant material (translucent blue plastic covering).
plastic end pieces protect assembly, no exposed steel fibers to stick fingers.